|
| |
|
|
|
| |
| |
|
WGS #455H Heavy Duty 600 Plus Pound Capacity Pin Assembly |
| |
| This lanyard is for use with the WGS #400 Series and other 3/8" I.D. Intermittent Scarffold Restraint Building Anchors that are flush to the building's facade. This unit will consistently handle the USA/Federal & California OSHA and ANSI 600lb. load requirement. To engage or remove the pin from the anchor, push the button at the rear of the pin. The Lanyard wire rope, Choker and Snap-Hook are included and are 304 stainless steel. The Pin Unit is of alloy steels that have been plated as well as stainless steel. |
|
|
| |
WGS #55 Yoke/Lanyard Assembly |
| |
| This yoke/lanyard assembly is for use with the WGS #50 series and other 3/4" O.D. Intermittent Scaffold Restraint Building Anchors that extend from the building's facade. This unit will consistently handle the USA/Federal & California OSHA and ANSI 600lb. load requirement. To engage or remove the yoke from the anchor, slip it over or out from the building anchor. The Yoke, Lanyard wire rope, Choker, and Snap-Hook are of 304 Stainless Steel. |
| |
|
|
